东莞工厂降温公司和你分享地下室的通风问题如何来解决

东莞工厂降温公司和你分享地下室的通风问题如何来解决

高层建筑基底面积，面积至少一层，多几层，除了大多数地下车库，但往往设置了一些设备，建筑，如高低压配电室，消防控制室（地下室也有罐，进风机房，关闭通道，消毒通道扩散室，阀室等） ，游泳池泵等。因此，在工程设计中， 地下室的通风问题如何来解决成为了令人思考的问题，下面就来和大家简单介绍，如下：
    排气系统进入系统，应结合烟区建筑防火分区来考虑，这样有利于地下室兼作通风系统的排气系统，并不会出现方排气管交叉防火分区现象。因此，公司表示当使用的管道系统应满足通常的要求，排气烟和火。
    合理安排地下室通风排气管和排气口，通常与排气，排气管双打火灾和烟雾通风口;地下室认为自然从车道入口，其他层通常由兼作空气系统送风系统火起来。每个通风，排风和送风系统上应设置轴，进风口应设在地面上干净的地方，如果有一定的距离主楼地下更好，其影响将受到影响的小气体灭火;主要与地面的建筑物，如果有一定的距离，更好的，其影响将是小的火和烟，排风口附楼内以上，应设在地面上的排气，以减少对环境的影响。
    通风，排风和送风风机选型排气，排烟风机离心风机或可选的高温轴流风机。厂家表示普通离心风机排烟能满足要求，但离心风机的风可以安装在地面上，占地大，需要一个较大的房间，耐高温轴流风机为消防专用风机，但也能满足烟气温度在280 ℃的要求运行30分钟，而高温轴流风机，体积小，起重，假设房间面积也小，实际工程设计中，往往采用高温轴流风机排风。
    上诉就是东莞市华钛制冷设备科技有限公司提供的信息，该公司提供车间降温设备、环保空调、负压风机、离心风机、降温水帘，并且承接各种车间降温工程、厂房降温工程、通风降温工程等，高质量的产品为你提供专业的服务，欢迎来电咨询：***（韩）

High-rise building basement area, area of at least one layer, the multi layers, in addition to most of the underground garage, but often set the equipment, buildings, such as high and low voltage power distribution room, fire control room (the basement also has a tank, air inlet room, close the channel, channel disinfection diffusion chamber and valve chambers and other), swimming pool pump. Therefore, in the engineering design, the problem of how to solve the problem of the basement of the basement is a thinking problem, the following plant cooling company to and we simply introduce, as follows:
Exhaust system into the system, should be combined with the tobacco growing areas of building fire protection partitions to consider, which is conducive to the exhaust system of underground room doubles as a ventilation system, and will not appear the exhaust side zoned phenomenon of the cross fire tube. Therefore, the plant cooling equipment company said when the use of piping system should meet the usual requirements, exhaust smoke and fire.
Reasonable arrangements for the basement ventilation exhaust pipe and an exhaust port, usually with the exhaust, exhaust pipe doubles fire and smoke vents; basement that natural from the entrance lane, the other layer is usually by doubles as air system send wind system fire up. Each ventilation, air exhaust and air supply system should be provided with a shaft, and the air inlet should be located in the ground clean, if there is a certain distance from the ground floor of main building better, its impact will be affected by the small gas fire extinguishing; mainly with ground buildings, if there is a certain distance, better, its influence will be small fire and smoke, row above the tuyere is attached to the building, should be located on the ground of the exhaust to reduce impact on the environment.
Air, exhaust fan, exhaust fan, centrifugal fan or optional high temperature axial fan. Plant cooling equipment manufacturers said ordinary centrifugal fan can meet the requirements, but the wind can be installed on the ground, the ground floor, need a larger room, high temperature axial fan for fire special fans, but also can meet the gas temperature at 280 degrees for 30 minutes, while the high temperature axial flow fan, small, assuming room area is small, the actual engineering design, often use high temperature axial flow fan.
Information provided by the appeal is the Dongguan City Ti Hua refrigeration equipment Technology Co., Ltd., the company provide workshop cooling equipment, environmental protection, air conditioning, suction fan, centrifugal fan, cooling water curtain, and to undertake all kinds of cooling plant engineering, plant cooling, ventilation and cooling engineering etc., high quality products to provide you with professional service, welcome to inquire: *** (South Korea)